Byran writes
It started out as a joke between myself and Josh (one of the testers at Bluefruit). I had the traffic lights in my office as I was preparing a stand to promote the outreach events (Summer Huddle, Mission to Mars, etc...) Software Cornwall runs. The conversation went on to alternative uses for the traffic lights, I was planning to see if people would pay attention to the traffic lights if I put them in a corridor at the event; we then came up with the idea that we could use them to indicate TDD test status.
Although it started out as a joke I am going to use it at the Summer Huddle, the lights change every time anyone runs a test so it should give an idea of how the entire group are doing without highlighting an individual pair.
The software setup is very simple, there is a Python web server (using the Flask library) running on a Raspberry Pi that controls the traffic lights using GPIO Zero. When the appendTestTrafficLight() function (in run_tests.js.erb) appends the traffic light image to the webpage I made it send an http 'get' request to the Raspberry Pi web server to set the physical traffic lights at the same time. At the moment the IP address of the Raspberry Pi is hard coded in the 'run_tests.js.erb' file so I have to rebuild the web image if anything changes but it was only meant to be a joke/proof of concept. The code is on a branch called traffic_lights on my fork of the cyber-dojo web repository.
The hardware is also relatively simple, there is a converter board on the Pi; this only converts the IO pin output connector of the Raspberry Pi to the cable that attaches to the traffic lights.
The other end of the cable from the converter board attaches to the board in the top left of the inside the traffic lights; this has some optoisolators that drive the relays in the top right which in turn switch on and off the transformers (the red thing in the bottom left) that drive the lights.
I have to give credit to Steve Amor for building the hardware for the traffic lights. They are usually used during events we run to teach coding to children (and sometimes adults). The converter board has LEDs, switches and buzzers on it to show that there isn't a difference between writing software to toggle LEDs vs driving actual real world systems, it's just what's attached to the pin. Having something where they can run the same code to drive LEDs and drive real traffic lights helps to emphasise this point.
